Design of Mechanical and Thermal Systems
Aniekan Essienubong Ikpe; Ekpenyong Akanimo Udofia; Emmanuel Odeh
Abstract
Cooling refrigeration systems ingest prime energy and contribute to universal negative impact due to ecologically unfavorable working fluids used. Hence, the quest to improve the performance of Vapour Compression Refrigeration System (VCRS) with more efficient and eco-friendly refrigerant such as nanoparticles ...
Read More
Cooling refrigeration systems ingest prime energy and contribute to universal negative impact due to ecologically unfavorable working fluids used. Hence, the quest to improve the performance of Vapour Compression Refrigeration System (VCRS) with more efficient and eco-friendly refrigerant such as nanoparticles becomes imperative. In this study, performance analysis of hybrid nanofluids-zeotropic mixtures in a VCRS were experimentally investigated to determine the best operating optimum performance using exergy based approach. To achieve this, varying concentrated mixtures were selected using ternary graph. The results revealed that all the designated ratios of the mixed refrigerant with different fractions achieved good performance improvement with optimum values obtained at (011) zero gram of TiO2, 7.5g-Al2O3/CuO. All the selected hybrid mixtures led to an improved outcome in terms of Coefficient of Performance (COP), less power consumption and high performance exergetic efficiency, with COP values ranging from 0.31% to 3.10% and exergetic efficiency from 0.32 to 1.43%. The value for thermal conductivity, dynamic viscosity, density and specific heat were found to be highest (0.0958 W/m.K; 0.00164 W/m.K; 686.82 kg/m3 and 359.82 kJ/kg.K) at the same concentration of zero grams TiO2 in the mixture. Comparison made from the performance characteristics curve (with global parameters) indicated that maximum power coefficient and cooling capacity for the various concentrations were found at (001) 7.5g-TiO2, zero grams Al2O3/CuO equal to 2.2 kW, and the minimum value at concentration of 5 was 0.61% at (111) 5g-TiO2/Al2O3/CuO, and 0.87% for (121). An increase was observed in the maximum power coefficient, cooling capacity and COP increased by 13.51%, 5.78% and 10.33%. It was also observed that hybrid nanofluid-zeotropic refrigerant worked seamlessly with VRCS, making it a sustainable, green and clean as well as eco-friendly alternative with near-zero to zero negative effects on public health safety and environment.
Design of Mechanical and Thermal Systems
Ekpenyong Akanimo Udofia; Aniekan Essienubong Ikpe; Victor Etok Udoh
Abstract
In this paper, the performance characteristics of a fabricated horizontal axis wind turbine with and without flanged diffusers were studied using wind tunnel experiment. Measurements of global parameters (power, torque, rotational speed efficiency, etc.) were carried out at wind speed regime between ...
Read More
In this paper, the performance characteristics of a fabricated horizontal axis wind turbine with and without flanged diffusers were studied using wind tunnel experiment. Measurements of global parameters (power, torque, rotational speed efficiency, etc.) were carried out at wind speed regime between 3-7 m/s. Flanged diffusers of five different inlet-outlet diameter ratios were employed. The results showed minimum mean increments in tip-speed ratios (TSR) of about 45 % with the smallest diffuser and a maximum of 80 % with the largest diffuser. Increments in the torque even at modest wind speed of 4 m/s were as much as 65, 70 and 76 % for the largest three diffusers and about 33 % for the smaller diffuser. The power output (with and without diffuser) gradually increased from 3-7 m/s wind speed, while the power coefficient (Cp) increased from 3-5.5 m/s, and thereafter began to fluctuate as the wind speed approached 7 m/s. Comparatively, maximum Cp of the turbine without diffuser was 0.22 for λ=0.534 at a wind speed of 7 m/s, while the maximum average value of Cp for turbine with flanged diffuser 3 was 0.34 for λ=0.706 at the same wind speed. As a result of the flanged diffuser attachment, the maximum Cp increased by 36 %. The results showed mean incremental values of 52 and 57 % with the greater value obtained from the second largest diffuser (Di/Do = 0.70) and the least value from the largest diffuser (Di/Do = 0.80), while the first three diffusers achieved near identical increments of 55 %. This consequently implies that increments in the extracted power (i.e., Cp) above 5 m/s wind speed declined with indications of separation and turbulence in the flows beyond the rotor.